2017 New Style FEP Encapsulated O-Ring to Iceland Importers
2017 New Style FEP Encapsulated O-Ring to Iceland Importers Detail:
Encapsulated O Ring adopts special rubber resisting high temperature, F+ plastic and special engineering to compound this sealing product. It not only has low contraction permanent set functions of rubber O Ring, but also resistant heat, cold oil, friction, chemical corrusion and other performances. It can be used in all kind of dynamical seal and static seal widely, meanwhile can replace all traditional rubber and plastic O Ring.
Technical Data Sheet
|
Property |
Unit |
Result |
|||
|
A |
B |
C |
|||
|
Normal Conditions |
Hardness |
JIS Hs |
70~90 |
70~90 |
60~75 |
|
Elongations(min.) |
% |
60 |
60 |
80 |
|
|
Tensile Stress(min) |
Mpa |
16 |
16 |
16 |
|
|
Compressibility |
% |
50~60 |
50~60 |
60~75 |
|
|
Recovery |
% |
＞85 |
＞85 |
＞70 |
|
|
Permanentset |
% |
＜10 |
＜10 |
＜10 |
|
|
230°Cx24h hot air ageing |
Change of hardness(max) |
JIS Hs |
-5~+5 |
-5~+5 |
-5~+5 |
|
Change of Tensile Stress(max) |
% |
-15 |
-15 |
-15 |
|
|
Change of Elongation(max) |
% |
-20 |
-20 |
-20 |
|
|
Compression Permanentset |
175°Cx70h |
% |
≤20 |
≤20 |
≤20 |
|
Color |
|
|
Brown |
Black |
Red |
|
Applications |
Temperature Limited |
℃ |
-20~+250 |
-20~+200 |
-20~+200 |
|
Pressure Limited |
Mpa |
0~35 |
|||
|
Working Environment |
|
Strong Caustics, moderate acids, chlorine, gases, water, steam, hydrocarbons, hydrogen and aluminum fluoride except element fluorine and fusion sodium. |
|||
Product detail pictures:
Related Product Guide:
O-Ring Sizes for Industrial Applications
Useful Tips For Installing The Teflon Envelope Gasket
2017 New Style FEP Encapsulated O-Ring to Iceland Importers, The product will supply to all over the world, such as: , , ,
After i got done siliconing and painting my box, I figured I’ll make a ‘How to’ video on sealing the gap between the subwoofer and the box. My total cost out of pocket to just seal the gap was less $15 after tax. But prices may vary depending on the hardware store that’s nearest to you.
There was a couple of things I forgot to mention in the video. When you you apply the weather stripping, make sure the surface area is clean and free of any dust. Second, and most important, once you have the mounting hole of the sub lined up with mounting holes, DON’T put a lot of presseure when tightening the screws. Put to much pressure and you’ll push the t-nut out of it’s place. Happened to me twice, hahaha!
So, yeah, just put enough pressure to let the screw tighten. Then once it’s tight, you can torque down the screw tight enough so it won’t come loose.
Thanks for watching my vid, and please rate.
mastagoof
By from -
By from -
