12 Years Factory wholesale Expanded PTFE Tape to Brasilia Factory
12 Years Factory wholesale Expanded PTFE Tape to Brasilia Factory Detail:
Expanded PTFE sealant tape possesses all the properties of PTFE, resistant to all the corrosive media.
Soft, twistable and bendable at will. Even if gravely rusted and worn out sealing face, as long as it is used, the equipment units may continue their service and the sealing can keep its best performance.
Excellent anti-wriggle variation ability and cold current resistance. Even in case of cross change of temperature and pressure, good sealing can be assured.
l Easy use and replacement
l Wide service scope.
Technical Data Sheet
No.
|
Project |
Technical Indexes |
1 |
PH Range |
0-14 |
2 |
Density |
0.7-0.8g/cm3 |
3 |
Temperature resistance |
-260-+260℃ |
4 |
High pressure resistance |
20~25Mpa |
5 |
Elongation |
20~30% |
6 |
Tensile strength |
30~35Mpa |
Regular Size
NO. |
SIZE |
NO. |
SIZE |
1 |
3mm*1.5mm*30m |
15 |
16mm*4mm*10m |
2 |
3mm*2mm*30m |
16 |
20mm*3mm*5m |
3 |
6mm*3mm*20m |
17 |
20mm*4mm*5m |
4 |
7mm*2.5mm*20m |
18 |
20mm*5mm*5m |
5 |
9mm*3mm*15m |
19 |
20mm*7mm*5m |
6 |
9mm*4mm*15m |
20 |
25mm*4mm*5m |
7 |
10mm*3mm*10m |
21 |
25mm*5mm*5m |
8 |
10mm*4mm*10m |
22 |
25mm*8mm*5m |
9 |
10mm*5mm*10m |
23 |
25mm*10mm*5m |
10 |
12mm*3mm*10m |
24 |
30mm*3mm*5m |
11 |
12mm*4mm*10m |
25 |
30mm*4mm*5m |
12 |
12mm*5mm*10m |
26 |
40mm*4mm*5m |
13 |
12mm*6mm*10m |
27 |
50mm*4mm*5m |
14 |
14mm*5mm*10m |
28 |
100mm*0.5mm*10m |
Application Area
It can be widely used in diverse pipelines to seal flanges, enameled products, glass, rubber products, plastics, non-rusting graphite lining tower, heat exchanger, pressure container as linings and to seal their flanges, to seal the fillers of diverse pumps and valves and to seal much heavy-calibre flanges which are not so precise, have larger unflat area and irregular shapes and require not too large tighting force.
Product detail pictures:
Related Product Guide:
Comparison of O-Ring Materials
What Is A PTFE Ring Gasket?
12 Years Factory wholesale Expanded PTFE Tape to Brasilia Factory, The product will supply to all over the world, such as: , , ,
How to re-caulk a inground pool deck. Removing the old caulk, I used a 5-1 painters knife. The backer rod/ caulk saver foam was from Lowes (in the weather strip area) and the size I used was 5/8″ (will vary based on crack size) . The caulk also came from Lowes in the concrete section. Some small areas did leak through causing a hole or gap. the next day I skimmed a little latex caulk over the hole then after it dried added another coat of the self leveling caulk to cover the latex caulk.
By from -
By from -