factory Outlets for Spiral Wound Gasket-CGI for Bahrain Factory
factory Outlets for Spiral Wound Gasket-CGI for Bahrain Factory Detail:
Spiral wound gasket consists of “V-shape”(or”W-shape”)metal tape and nonmetal tape, which are overlapped each other and wound continuously.To fasten the metal tape,both its start point and end point are tack welded.
Feature
Wide Scope of acceptable working conditions. Can be used under high temperature, high pressure and ultra-low temperature or vacuum conditions. Change the combination of the gasket materials is to tackle the chemical corrosion problem of diverse media toward the gasket.
Not very rigid requirements to the surface precision of the flange. May be used to seal flanges with rough surface
Easy installation and handy use.
Excellent Sealability
Products Type
Technical Data Sheet
|
Product&Type |
Size（mm） |
Temperature(℃) |
Pressure（Mpa） |
|
Spiral Wound Gasket filled with Graphite
|
φ16~φ3200 |
(In Oxidizing Environment )-240~+550℃；(In non-Oxidizing Environment)-240~+870℃ |
(Under hot water, oil etc. )30 Mpa; (Under vapor oil, gases etc.)20 Mpa |
|
Spiral Wound Gasket filled with Asbestos
|
φ16~φ3200 |
-150~+450℃ |
15 |
|
Spiral Wound Gasket filled with PTFE
|
φ16~φ3200 |
-200~+250℃ |
15 |
Application Area
The Spiral Wound Gaskets are mainly used in valves &pipes, pressure vessel, condenser, heat exchanger flanges in oil, chemical, metallurgy, vessel and mechanical industries.
Product detail pictures:
Related Product Guide:
A Look at the Molded Gasket
Comparison of O-Ring Materials
factory Outlets for Spiral Wound Gasket-CGI for Bahrain Factory, The product will supply to all over the world, such as: , , ,
How to rebuild the front windshield hydraulic latch cylinders on a Mercedes R129..W124 models rear latch and more recent clk are very similar..The seal kit was from Konstantin Belov at MBseals https://www.mbseals.com/
He was really good to deal with and shipped very quickly..he uses an upgraded seal that will resist the leakage problems the original seals have..The latch cylinders are very easy to do yourself,unlike the main cylinders which would be better left to a professional rebuilder…I can not stress enough that you purchase the correct hydraulic fluid from a Mercedes dealership when topping up the fluid. follow me on twitter https://twitter.com/fupabox
By from -
By from -
