Manufacturer of FEP Encapsulated O-Ring to Puerto Rico Manufacturers
Manufacturer of FEP Encapsulated O-Ring to Puerto Rico Manufacturers Detail:
Encapsulated O Ring adopts special rubber resisting high temperature, F+ plastic and special engineering to compound this sealing product. It not only has low contraction permanent set functions of rubber O Ring, but also resistant heat, cold oil, friction, chemical corrusion and other performances. It can be used in all kind of dynamical seal and static seal widely, meanwhile can replace all traditional rubber and plastic O Ring.
Technical Data Sheet
|
Property |
Unit |
Result |
|||
|
A |
B |
C |
|||
|
Normal Conditions |
Hardness |
JIS Hs |
70~90 |
70~90 |
60~75 |
|
Elongations(min.) |
% |
60 |
60 |
80 |
|
|
Tensile Stress(min) |
Mpa |
16 |
16 |
16 |
|
|
Compressibility |
% |
50~60 |
50~60 |
60~75 |
|
|
Recovery |
% |
＞85 |
＞85 |
＞70 |
|
|
Permanentset |
% |
＜10 |
＜10 |
＜10 |
|
|
230°Cx24h hot air ageing |
Change of hardness(max) |
JIS Hs |
-5~+5 |
-5~+5 |
-5~+5 |
|
Change of Tensile Stress(max) |
% |
-15 |
-15 |
-15 |
|
|
Change of Elongation(max) |
% |
-20 |
-20 |
-20 |
|
|
Compression Permanentset |
175°Cx70h |
% |
≤20 |
≤20 |
≤20 |
|
Color |
|
|
Brown |
Black |
Red |
|
Applications |
Temperature Limited |
℃ |
-20~+250 |
-20~+200 |
-20~+200 |
|
Pressure Limited |
Mpa |
0~35 |
|||
|
Working Environment |
|
Strong Caustics, moderate acids, chlorine, gases, water, steam, hydrocarbons, hydrogen and aluminum fluoride except element fluorine and fusion sodium. |
|||
Product detail pictures:
Related Product Guide:
A Look at the Molded Gasket
O-Ring Sizes for Industrial Applications
Manufacturer of FEP Encapsulated O-Ring to Puerto Rico Manufacturers, The product will supply to all over the world, such as: , , ,
NKG, back to back (shaft seal, HJ92N-HJ92N)
Table of contents:
Dismantling:
00:00 Removing the pump housing
02:41 Removing the impeller
03:52 Removing the primary shaft seal
05:19 Removing the secondary shaft seal
Assembly:
06:10 Fitting the secondary shaft seal
08:31 Fitting the primary shaft seal
10:56 Fitting the impeller
12:04 Fitting pump housing
15:28 Wear ring replacement
Recorded: January 2010
For more information please visit:
https://www.grundfos.com/service-support.html
When the gearbox oil on an outboard either leaks out entirely or gets emulsified, it is generally because on or more of the oil seals have failed. In this case it is the oil seals around the prop shaft of a Yamaha outboard have been damaged by fishing line.
This video covers removing the bearing carrier from the gearbox, removing the oil seals and then installing the new ones. The final step before putting new oil back in the gearbox is to pressure test the gearbox to make sure the fix has worked.
By from -
By from -
