18 Years Factory offer NBR O-Ring for El Salvador Manufacturer

Short Description:

Nitrile rubber (NBR, Buna-N) provides excellent resistance to petroleum oils as well as mineral and vegetable oil. Nitrile rubber also offers strong resistance to heat aging – often a key advantage over natural rubber. Technical Data Sheet Color Black or Color Material Nitrile(NBR) Hardness(Shore A) 65~75 Temperature(℃) -30~+120 Tensile Strength(Mpa) 14 Elongation at Break(%) 384 Density(g/cm3) 1.2   Application Area Nitrile rubber performs well in carburetor and fuel...


Product Detail

Product Tags

Related Video

Feedback (2)

, , ,
18 Years Factory offer NBR O-Ring for El Salvador Manufacturer Detail:

Nitrile rubber (NBR, Buna-N) provides excellent resistance to petroleum oils as well as mineral and vegetable oil. Nitrile rubber also offers strong resistance to heat aging – often a key advantage over natural rubber.

Technical Data Sheet

Color Black or Color
Material Nitrile(NBR)
Hardness(Shore A) 65~75
Temperature(℃) -30~+120
Tensile Strength(Mpa) 14
Elongation at Break(%) 384
Density(g/cm3) 1.2

 

Application Area

Nitrile rubber performs well in carburetor and fuel pump diaphragms, aircraft hoses, seals and gaskets as well as oil-lined tubing. Due to its versatility, nitrile is used in applications involving not only oil and fuel resistance, but those applications requiring resistance to heat, abrasion, water, and gas permeability.


Product detail pictures:

18 Years Factory offer
 NBR O-Ring for El Salvador Manufacturer detail pictures


Related Product Guide:
Comparison of O-Ring Materials
A Look at the Molded Gasket

18 Years Factory offer NBR O-Ring for El Salvador Manufacturer, The product will supply to all over the world, such as: , , ,


  • This video shows the manual stretching of a single 5 µm-arm silicon spiral
    for 8 cycles, which demonstrates mechanical robustness and
    reliability. Read more: https://www.nanowerk.com/spotlight/spotid=37799.php



    NKG, back to back (shaft seal, MG12-MG1)

    Table of contents:

    Dismantling:
    00:00 Removing the pump housing
    02:41 Removing the impeller
    04:03 Removing the primary shaft seal
    05:15 Removing the secondary shaft seal

    Assembly:
    06:06 Fitting the secondary shaft seal
    08:36 Fitting the primary shaft seal
    10:31 Fitting the impeller
    11:41 Fitting pump housing

    15:04 Wear ring replacement

    Recorded: January 2010

    For more information please visit:

    https://www.grundfos.com/service-support.html


    5 Stars By from -

    5 Stars By from -

    Related Products