OEM Factory for Spiral Wound Gasket-CGI to Luxembourg Manufacturers
OEM Factory for Spiral Wound Gasket-CGI to Luxembourg Manufacturers Detail:
Spiral wound gasket consists of “V-shape”(or”W-shape”)metal tape and nonmetal tape, which are overlapped each other and wound continuously.To fasten the metal tape,both its start point and end point are tack welded.
Feature
Wide Scope of acceptable working conditions. Can be used under high temperature, high pressure and ultra-low temperature or vacuum conditions. Change the combination of the gasket materials is to tackle the chemical corrosion problem of diverse media toward the gasket.
Not very rigid requirements to the surface precision of the flange. May be used to seal flanges with rough surface
Easy installation and handy use.
Excellent Sealability
Products Type
Technical Data Sheet
|
Product&Type |
Size（mm） |
Temperature(℃) |
Pressure（Mpa） |
|
Spiral Wound Gasket filled with Graphite
|
φ16~φ3200 |
(In Oxidizing Environment )-240~+550℃；(In non-Oxidizing Environment)-240~+870℃ |
(Under hot water, oil etc. )30 Mpa; (Under vapor oil, gases etc.)20 Mpa |
|
Spiral Wound Gasket filled with Asbestos
|
φ16~φ3200 |
-150~+450℃ |
15 |
|
Spiral Wound Gasket filled with PTFE
|
φ16~φ3200 |
-200~+250℃ |
15 |
Application Area
The Spiral Wound Gaskets are mainly used in valves &pipes, pressure vessel, condenser, heat exchanger flanges in oil, chemical, metallurgy, vessel and mechanical industries.
Product detail pictures:
Related Product Guide:
A Look at the Molded Gasket
Comparison of O-Ring Materials
OEM Factory for Spiral Wound Gasket-CGI to Luxembourg Manufacturers, The product will supply to all over the world, such as: , , ,
The aim of tightening a compression joint is to create a gas tight joint without compressing the olive too tight on the pipe by over tightening the nut as this will restrict flow through the pipe as the pipe will have been made internally smaller.
GAS IT and FES Autogas Ltd do not accept any liability from users following this video or information we provide.
We highly recommend getting a GAS IT Trained Dealer or Qualified Gas engineer to check your installation and fitment of GAS IT parts prior to filling and using it with LPG/ Autogas.
By from -
By from -
