Manufacturing Companies for Arcylic Fiber Braided Packing Wholesale to UK
Manufacturing Companies for Arcylic Fiber Braided Packing Wholesale to UK Detail:
Arcylic fiber packing braided from high strength arcylic fiber with PTFE impregnated twice time. It has excellent properties of sealing, lubricating and resistant to chemical. The arcylic packing can be with or without oil. High elastic red silicone rubber core can absorb vibration.
Technical Data Sheet
|
|
Rotating |
Reciprocating |
Valves |
|
Pressure |
2Mpa |
10Mpa |
20Mpa |
|
Shaft Speed |
20m/s rotary |
||
|
Temperature |
-100℃~+280℃ |
||
|
PH Range |
2~12 |
||
Application Area
Usually used in pumps and valves, and can handle more chemicals except strong acid, strong alkali and strong oxidizer.
Product detail pictures:
Related Product Guide:
Comparison of O-Ring Materials
What Is A PTFE Ring Gasket?
Manufacturing Companies for Arcylic Fiber Braided Packing Wholesale to UK, The product will supply to all over the world, such as: , , ,
https://viperperformance.co.uk Viper Performance AN Flare Plug, ORB Slimline Plug and NPT (male) Plug technical demonstration video
To find out more about the AN Flare Plug visit: https://www.viperperformance.co.uk/fuel-hose-fittings-and-separators_10001_plugan-flare-plugs.html
To find out more about the ORB Slimline Plug visit: https://www.viperperformance.co.uk/fuel-hose-fittings-and-separators_10110_plugorb-slimline.html
To find out more about the NPT (male) Plug visit: https://www.viperperformance.co.uk/fuel-hose-fittings-and-separators_10002_plugnpt-male-plugs.html
After i got done siliconing and painting my box, I figured I’ll make a ‘How to’ video on sealing the gap between the subwoofer and the box. My total cost out of pocket to just seal the gap was less $15 after tax. But prices may vary depending on the hardware store that’s nearest to you.
There was a couple of things I forgot to mention in the video. When you you apply the weather stripping, make sure the surface area is clean and free of any dust. Second, and most important, once you have the mounting hole of the sub lined up with mounting holes, DON’T put a lot of presseure when tightening the screws. Put to much pressure and you’ll push the t-nut out of it’s place. Happened to me twice, hahaha!
So, yeah, just put enough pressure to let the screw tighten. Then once it’s tight, you can torque down the screw tight enough so it won’t come loose.
Thanks for watching my vid, and please rate.
mastagoof
By from -
By from -
