Good Quality PTFE Graphite Braided Packing Export to Sevilla

It is a braided packing made of PTFE yarn containing graphite. It is recommended for shafts for almost all chemicals. Stability and long service lift are achieved by low friction coefficient. It has great tear strength and high thermal conductivity. This self lubrication packing does not score the shaft and minimizes sleeve rep, acement cost. It can be used to seal alkalis, solvents, water, steam, acids except strong oxidizing acids( aqua regia, fuming nitric acid, fuming nitric acid, fuming sulfuric acid,etc.) for centrifugal pumps, autoclaes, agitators mixers, etc.

Technical Data Sheet

 Application Area

It can be used to seal alkalis, solvents, water, steam, for centrifugal pumps, autoclaves, agitators, mixers, etc.

hydraulic compactor main for cardboard
with high pressure power
voltage can be design by require
with CE certificate
The basic principle of horizontal hydraulic metal baler that is the use of metallic materials in the external force, to the nature of the plastic deformation, to the satisfaction of the metal material (packer, can set and permanent deformation occurs external force, then constitute tight beam blocks can not be plastically deformed, metallic or plastic deformation is small, can not be directly packaged for disposal. such as high carbon steel, tool steel, wire rope and cast iron, etc., can not be directly installed packaged.
Horizontal hydraulic metal baler basic needs:
(1) have a satisfactory kneading force. Metallic material is disposed to make plastic deformation bundle block, and the block is beam must reach the density of demand.
(2) there must be an inclusive metal materials, and can be closed up to accept kneading force bins. In satisfaction of these two basic needs of the premise, but not the same application based on the needs and goals are not the same disposition, it has undergone many different types of metal horizontal hydraulic baler. Horizontal hydraulic metal baler operation principle, that is, the material in a closed box, use the job force pushing the indenter kneading the metal material, the metal material constituting the beam block must scale and density.