Manufacturer for PTFE Graphite Packing with Aramid Corner for Thailand Factory
Manufacturer for PTFE Graphite Packing with Aramid Corner for Thailand Factory Detail:
PTFE graphite packing with aramid corner is made from aramid yarns impregnated with PTFE, while the friction faces are made of graphite PTFE yarns. The graphite particle in PTFE yarn enhances the heat exchange efficiency.
Technical Data Sheet
|
|
Rotating |
Reciprocating |
Valves |
|
Pressure |
4Mpa |
15Mpa |
25Mpa |
|
Shaft Speed |
20m/s rotary |
||
|
Temperature |
-200℃~+280℃ |
||
|
PH Range |
2~12 |
||
Application Area
It affords longer service life under severe conditions which conventional asbestos packing can bot provide satisfaction, such as mine, tin ore, paper pulp, feed water pump of power stations, etc.
Product detail pictures:
Related Product Guide:
A Look at the Molded Gasket
What Is A PTFE Ring Gasket?
Manufacturer for PTFE Graphite Packing with Aramid Corner for Thailand Factory, The product will supply to all over the world, such as: , , ,
NKG, back to back (shaft seal, MG12-MG1)
Table of contents:
Dismantling:
00:00 Removing the pump housing
02:41 Removing the impeller
04:03 Removing the primary shaft seal
05:15 Removing the secondary shaft seal
Assembly:
06:06 Fitting the secondary shaft seal
08:36 Fitting the primary shaft seal
10:31 Fitting the impeller
11:41 Fitting pump housing
15:04 Wear ring replacement
Recorded: January 2010
For more information please visit:
https://www.grundfos.com/service-support.html
By from -
By from -
