Manufacturer for Carbon Fiber Packing Impregnated with PTFE to Comoros Importers

Short Description:

Diagonal braided to form a dense but pliable packing, each carbon fiber is pre-impregnated with PTFE, and re-impregnated during square braided. It is premium service packing for media of weak chemical corrosion and grains of particles exit. Technical Data Sheet   Rotating Reciprocating Valves Pressure 3Mpa 10Mpa 25Mpa Shaft Speed 15m/s rotary Temperature -200℃~+280℃ PH Range 2~12  Application Area Resist all the strong corrosive media and media with a...


Product Detail

Product Tags

Related Video

Feedback (2)

, , ,
Manufacturer for Carbon Fiber Packing Impregnated with PTFE to Comoros Importers Detail:

Diagonal braided to form a dense but pliable packing, each carbon fiber is pre-impregnated with PTFE, and re-impregnated during square braided. It is premium service packing for media of weak chemical corrosion and grains of particles exit.

Technical Data Sheet

 

Rotating

Reciprocating

Valves

Pressure

3Mpa

10Mpa

25Mpa

Shaft Speed

15m/s rotary

Temperature

-200℃~+280℃

PH Range

2~12

 Application Area

Resist all the strong corrosive media and media with a few crystal particles with the exception of the strong oxidizing agent polonium, chiefly used for the sealing of the centrifugal pump, column pump, mixer and valves.


Product detail pictures:

Manufacturer for
 Carbon Fiber Packing Impregnated with PTFE to Comoros Importers detail pictures


Related Product Guide:
Comparison of O-Ring Materials
A Look at the Molded Gasket

Manufacturer for Carbon Fiber Packing Impregnated with PTFE to Comoros Importers, The product will supply to all over the world, such as: , , ,


  • Link to project page: https://www.disneyresearch.com/publication/fluid-soft-actuator/

    We have developed a new method for puppeteers to remotely control mechanical characters without the use of motors. The pair of robot arms shown in this video are connected only by flexible pneumatic tubing. There are no pumps, valves, sensors, motors, or electronic controllers used. The passive connection between the two arms is made entirely by air pressure, allowing a large separation between the character and the puppeteer, and tight bends in the air control lines. The key technology is an ultra-low friction pneumatic transmission, enabled by the use of rolling diaphragm seals, instead of traditional sliding o-ring seals. If motorized, the transmission allows the motors to be placed in the body, rather than mounted to the arm, leaving the arms much lighter, and capable of faster and more graceful motion. The robot arm in this video was designed and built by Tianyao Chen, Peter Whitney, and Jessica Hodgins.


    5 Stars By from -

    5 Stars By from -

    Related Products