High definition wholesale Spiral Wound Gasket-RIR to Bolivia Manufacturer
High definition wholesale Spiral Wound Gasket-RIR to Bolivia Manufacturer Detail:
Spiral wound gasket consists of “V-shape”(or”W-shape”)metal tape and nonmetal tape, which are overlapped each other and wound continuously.To fasten the metal tape,both its start point and end point are tack welded.
Feature
Wide Scope of acceptable working conditions. Can be used under high temperature, high pressure and ultra-low temperature or vacuum conditions. Change the combination of the gasket materials is to tackle the chemical corrosion problem of diverse media toward the gasket.
Not very rigid requirements to the surface precision of the flange. May be used to seal flanges with rough surface
Easy installation and handy use.
Excellent Sealability
Products Type
Technical Data Sheet
|
Product&Type |
Size（mm） |
Temperature(℃) |
Pressure（Mpa） |
|
Spiral Wound Gasket filled with Graphite
|
φ16~φ3200 |
(In Oxidizing Environment )-240~+550℃；(In non-Oxidizing Environment)-240~+870℃ |
(Under hot water, oil etc. )30 Mpa; (Under vapor oil, gases etc.)20 Mpa |
|
Spiral Wound Gasket filled with Asbestos
|
φ16~φ3200 |
-150~+450℃ |
15 |
|
Spiral Wound Gasket filled with PTFE
|
φ16~φ3200 |
-200~+250℃ |
15 |
Application Area
The Spiral Wound Gaskets are mainly used in valves &pipes, pressure vessel, condenser, heat exchanger flanges in oil, chemical, metallurgy, vessel and mechanical industries.
Product detail pictures:
Related Product Guide:
Comparison of O-Ring Materials
Useful Tips For Installing The Teflon Envelope Gasket
High definition wholesale Spiral Wound Gasket-RIR to Bolivia Manufacturer, The product will supply to all over the world, such as: , , ,
How to properly install a butterfly valve onto a Poly Processing IMFO®, Integrally Molded Flanged Outlet, polyethylene tank. When installing larger assemblies like a valve or flex joint on to a poly tank, an extra set of hands is helpful. Start with the gasket against the IMFO®. Hold the valve against it, take the backing ring and place it on.
Now insert one all-thread and through the front of the assembly. Add a wedge washer, flat washer, and nut to the back of the assembly.
Now that we’e added hardware to the back of the all thread, add the flex joint to the front of the butterfly valve. An important note at this stage is to not leave out the included spacer. The spacer is very important when we use a PVC flange against a PTF and composite flex joint. With stainless steel flanges, these spacers would not be required. Just like on the back side of the IMFO®, we’re going to add hardware top the front side of the all threads. The only difference is that there will not be a wedge washer on this side of the hardware. Tighten each nut down in a criss-cross pattern. Once all hardware is tightened, a crow’s foot can be used to get in between the two flanges and use an actual torque wrench to tighten to 20 ft-lbs
Next, add the valve handle. Remove the retainer screw from the top of the assembly. Line up the pattern of the valve handle and press down in to place.
Learn more about polyethylene tanks and fittings: https://www.polyprocessing.com/
By from -
By from -
