OEM Factory for Spiral Wound Gasket-CG to Iraq Manufacturers
OEM Factory for Spiral Wound Gasket-CG to Iraq Manufacturers Detail:
Spiral wound gasket consists of “V-shape”(or”W-shape”)metal tape and nonmetal tape, which are overlapped each other and wound continuously.To fasten the metal tape,both its start point and end point are tack welded.
Feature
Wide Scope of acceptable working conditions. Can be used under high temperature, high pressure and ultra-low temperature or vacuum conditions. Change the combination of the gasket materials is to tackle the chemical corrosion problem of diverse media toward the gasket.
Not very rigid requirements to the surface precision of the flange. May be used to seal flanges with rough surface
Easy installation and handy use.
Excellent Sealability
Products Type
Technical Data Sheet
|
Product&Type |
Size（mm） |
Temperature(℃) |
Pressure（Mpa） |
|
Spiral Wound Gasket filled with Graphite
|
φ16~φ3200 |
(In Oxidizing Environment )-240~+550℃；(In non-Oxidizing Environment)-240~+870℃ |
(Under hot water, oil etc. )30 Mpa; (Under vapor oil, gases etc.)20 Mpa |
|
Spiral Wound Gasket filled with Asbestos
|
φ16~φ3200 |
-150~+450℃ |
15 |
|
Spiral Wound Gasket filled with Asbestos
|
φ16~φ3200 |
-150~+450℃ |
15 |
|
Spiral Wound Gasket filled with PTFE
|
φ16~φ3200 |
-200~+250℃ |
15 |
Application Area
The Spiral Wound Gaskets are mainly used in valves &pipes, pressure vessel, condenser, heat exchanger flanges in oil, chemical, metallurgy, vessel and mechanical industries.
Product detail pictures:
Related Product Guide:
What Is A PTFE Ring Gasket?
Comparison of O-Ring Materials
OEM Factory for Spiral Wound Gasket-CG to Iraq Manufacturers, The product will supply to all over the world, such as: , , ,
How to remove, clean, and reinstall the throttle body on a 4.2 inline 6 trailblazer.
This procedure is usually done if the engine idles rough or stalls with the a/c or defrost on AFTER the battery has been disconnected.
I also show an alternate method for resetting the pcm. (I found this tip in a post by mwfaith1971 on trailvoy)
Update 3/1/12 – Frequently asked questions:
Q- why do you pull those fuses?
A- to reset the pcm WITHOUT disconnecting the battery
Q- why don’t you disconnect the battery?
A- that could potentially cause hvac actuator failure, moreso in the older ones like my 03…YOU can reset the pcm however you want to in yours:)
Q- can I pull the fuses and then clean the throttle body?
A- absolutely!
Edit 7/2014 – Sorry looks like I have to close comments on this one. Too many peeps trying to promote their shitty channels and giving horrible advice. I’ve probably done this procedure more times then all of you assholes combined so I think I know what the fuck I’m talking about. Thanks for letting me know how much I suck, 169,000 peeps will tell you otherwise.
By from -
By from -
