China Manufacturer for Spiral Wound Gasket-RIR for Australia Manufacturer
China Manufacturer for Spiral Wound Gasket-RIR for Australia Manufacturer Detail:
Spiral wound gasket consists of “V-shape”(or”W-shape”)metal tape and nonmetal tape, which are overlapped each other and wound continuously.To fasten the metal tape,both its start point and end point are tack welded.
Feature
Wide Scope of acceptable working conditions. Can be used under high temperature, high pressure and ultra-low temperature or vacuum conditions. Change the combination of the gasket materials is to tackle the chemical corrosion problem of diverse media toward the gasket.
Not very rigid requirements to the surface precision of the flange. May be used to seal flanges with rough surface
Easy installation and handy use.
Excellent Sealability
Products Type
Technical Data Sheet
|
Product&Type |
Size（mm） |
Temperature(℃) |
Pressure（Mpa） |
|
Spiral Wound Gasket filled with Graphite
|
φ16~φ3200 |
(In Oxidizing Environment )-240~+550℃；(In non-Oxidizing Environment)-240~+870℃ |
(Under hot water, oil etc. )30 Mpa; (Under vapor oil, gases etc.)20 Mpa |
|
Spiral Wound Gasket filled with Asbestos
|
φ16~φ3200 |
-150~+450℃ |
15 |
|
Spiral Wound Gasket filled with PTFE
|
φ16~φ3200 |
-200~+250℃ |
15 |
Application Area
The Spiral Wound Gaskets are mainly used in valves &pipes, pressure vessel, condenser, heat exchanger flanges in oil, chemical, metallurgy, vessel and mechanical industries.
Product detail pictures:
Related Product Guide:
Comparison of O-Ring Materials
O-Ring Sizes for Industrial Applications
China Manufacturer for Spiral Wound Gasket-RIR for Australia Manufacturer, The product will supply to all over the world, such as: , , ,
This video shows the ATOM Flashcut dieless knife cutting machine nesting and cutting gasket sealing material.
Although this can be cut on any of the ATOM range of Flashcut’s, this is the general standard size bed for this application, giving the operator the ability to be unloading one half of the machine, relaod blank material and nest, whilst the second half of the machine is cutting. When the first zone is completed then the cutting beam will move over too the second half and restart, allowing the operator to be a continous production cycyle.
By from -
By from -
