15 Years Factory wholesale PTFE Graphite Braided Packing to Belgium Factory

Short Description:

It is a braided packing made of PTFE yarn containing graphite. It is recommended for shafts for almost all chemicals. Stability and long service lift are achieved by low friction coefficient. It has great tear strength and high thermal conductivity. This self lubrication packing does not score the shaft and minimizes sleeve rep, acement cost. It can be used to seal alkalis, solvents, water, steam, acids except strong oxidizing acids( aqua regia, fuming nitric acid, fuming nitric acid, fuming ...


Product Detail

Product Tags

Related Video

Feedback (2)

, , ,
15 Years Factory wholesale PTFE Graphite Braided Packing to Belgium Factory Detail:

It is a braided packing made of PTFE yarn containing graphite. It is recommended for shafts for almost all chemicals. Stability and long service lift are achieved by low friction coefficient. It has great tear strength and high thermal conductivity. This self lubrication packing does not score the shaft and minimizes sleeve rep, acement cost. It can be used to seal alkalis, solvents, water, steam, acids except strong oxidizing acids( aqua regia, fuming nitric acid, fuming nitric acid, fuming sulfuric acid,etc.) for centrifugal pumps, autoclaes, agitators mixers, etc.

Technical Data Sheet

 

Rotating

Reciprocating

Valves

Pressure

2Mpa

15Mpa

15Mpa

Shaft Speed

14m/s rotary

Temperature

-200℃~+280℃

PH Range

0~14

 Application Area

It can be used to seal alkalis, solvents, water, steam, for centrifugal pumps, autoclaves, agitators, mixers, etc.


Product detail pictures:

15 Years Factory wholesale
 PTFE Graphite Braided Packing to Belgium Factory detail pictures


Related Product Guide:
Useful Tips For Installing The Teflon Envelope Gasket
A Look at the Molded Gasket

15 Years Factory wholesale PTFE Graphite Braided Packing to Belgium Factory, The product will supply to all over the world, such as: , , ,


  • Shifts much better with 10W30 installed.
    As usual it’s difficult to get oil back into the manual transmission without a proper pump. Jeep design makes it handy to just pour oil in with a longer hose while standing beside front fender.
    Used a 90 degree fitting from Lowes that has a garden hose male to a small ~1/2″ male end. Seals into the garden hose female. Just pour in until oil starts dripping into catch pan below Jeep, re-install plug. Careful not to over tighten plug, just needs to be snug, the plug doesn’t fasten anything..


    5 Stars By from -

    5 Stars By from -

    Related Products