China Manufacturer for Spiral Wound Gasket-RIR for Australia Manufacturer

Spiral wound gasket consists of “V-shape”(or”W-shape”)metal tape and nonmetal tape, which are overlapped each other and wound continuously.To fasten the metal tape,both its start point and end point are tack welded.

Feature

Wide Scope of acceptable working conditions. Can be used under high temperature, high pressure and ultra-low temperature or vacuum conditions. Change the combination of the gasket materials is to tackle the chemical corrosion problem of diverse media toward the gasket.

Not very rigid requirements to the surface precision of the flange. May be used to seal flanges with rough surface

Easy installation and handy use.

Excellent Sealability

Products Type

Technical Data Sheet

 Application Area

The Spiral Wound Gaskets are mainly used in valves &pipes, pressure vessel, condenser, heat exchanger flanges in oil, chemical, metallurgy, vessel and mechanical industries.

Have you been fighting a mystery creak, chirp, or other bizarre noise that can’t be tracked down? Watch BikeCo’s Joe Binatena go through the steps of correcting bearing interface. Take Joe’s advice and check the easy stuff first – but if you are still struggling to find the cause of your noise these steps may save you a lot of heartache, hours of searching, and potential damage on your frame.

This is the first in a series of videos touching on locating and theories on addressing mystery creaks.