Wholesale Distributors for Serrated Gasket for Cambodia Manufacturer

1.Structure

Serrated Gasket is made of machined flat metallic plate with waved or corrugated surface in 90 degree angle.

The Serrated Gasket with inner and outer rings or composite gasket attached with flexible graphite or Teflon sheet are available depending on the working location and requirement.

2.Characteristic

Serrated Gasket is an idea gasket used in low pre-tightening, the soft sealing surface avoid metal to metal touch, can be combined reliably and closely, protect flange not to be damaged. This kind of gasket is suitable to high pressure and high temperature location. Strong corrosion resistance, stable and reliable sealing function.

3.Gasket Typ

   Basic Type                                        With outer Ring

4. Working Environment

Working Temperature：~650℃

Working Pressure：6.4-16.0MP

Min. Pre-tightening：y=70MPa

TERM Sealant Barrier – Termite barrier for plumbing penetrations
www.PolyguardBarriers.com

TERM Sealant Barrier is a sealant barrier, applied with a caulking gun or smoothing tool, and used for both waterproofing and insect
exclusion . TERM Sealant Barrier is a component of the non-structural TERM Barrier System which, when properly constructed as part of the building envelope, acts as a barrier to almost all pests. Because almost all pests are excluded for the life of the structure, the need for pesticide treatment should be permanently and drastically reduced.

Here are some of the places where it is used:
1. To seal slab penetrations above slab against termite entry
2. As a component of the TERM Full Bath Trap Barrier, to exclude
termites, fire ants, rodents, moles, etc. from entry underneath
bathtubs at ground level
3. To seal slab penetrations (prior to concrete pour) as a
component of the TERM Underslab Barrier
4. To detail small gaps found during construction in horizontal or
vertical portions of the TERM building envelope pest barrier.

Polyguard Products, Barrier Products Division

The Polyguard Particle Barrier is an insect exclusion product and is easy to install. Used around the perimeter of the building, it can significantly reduce the quantity of termiticides needed to protect the structure.

Polyguard has registered our barrier products with the EPA, who
along with state agencies regulates pesticides. However, Polyguard’s barriers are classified by the EPA as “devices”, since they contain no toxic components.

Termites trying to get into a structure are unable to penetrate the
Polyguard Particle Barrier. Also important, in the case of the
Reticuletermes flavipes species, is that the insects are unable to get out of a structure which they previously penetrated. In the majority of infested structures, there is not sufficient moisture in the building for Reticuletermes flavipes, so they have to come out to obtain moisture.